Braton Group Form Designer Betriebsanweisung PDF herunterladen (Seite 46)

Printing

In both cases (serial or parallel):

- The cable is connected to the

wrong port.

Check the connection.

A page is not printed For direct thermal printing: the

print media has been inserted the

wrong way (the print head is

heating the wrong side of the

paper).

Reinsert the media the right way.

For thermal transfer printing: The

ribbon has not been inserted, or

was inserted incorrectly.

Check the ribbon and refit if necessary (refer to

the manufacturer’s handbook).

The required print mode has not

been selected on the printer.

Check that the print mode (native or thermal

transfer) has been correctly selected on the

printer (refer to the manufacturer’s handbook)

or in the Printer setup dialog box.

A graphic object

(image, Windows

font, graphic barcode,

etc.) has not been

printed.

The printer is out of memory. Check the Clear memory at next print time

only option; If the problem persists, check the

amount of memory space allocated to images

(on the Images tab of your printer driver).

The printer does not have enough

memory.

Increase the amount of printer memory either

by adding an extra memory card, or by

increasing the RAM (refer to the manufacturer’s

manual or check with the dealer from which you

purchased the printer).

Some printers will not recognize an

object if it overlaps the edge of the

printable area, even by only a few

millimeters.

Adjust the position of the object on the label.

The thermal printer is

jammed

The print media used is not the

same as the one defined in the

Page setup dialog box (continuous

paper or with gap).

Check that the right print media was selected

during page setup: Continuous, With gap.

1 2 ... 41 42 43 44 45 46 47

Kommentare zu diesen Handbüchern

Keine Kommentare

Braton Group Form Designer Betriebsanweisung Seite 46

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Braton Group Form Designer